 |
 |
- CHP series is made of steel.
- It is suitable for holding thin wires, strings and other thin works.
- It is used for pull test.
 Tightening side |
|
|
- Examples
The breaking examination of the connector is being operated with
vertical load measuring stand (K-501H) and a push-pull gauge as below. The pin chuck (CHP-15) and vise (GV-500N)
are used. |
|
|
 |
|
The break down test of the soldered pin is being
operated with vertical load measuring stand (K-501H) and a push-pull gauge. The pin chuck (CHP-05) and X-Y table
(XYS-60) are used. |
|
|
| Standard specification |
| Model |
CHP-05 |
CHP-1 |
CHP-15 |
CHP-2 |
| External dimensional drawing |
CLICK! |
CLICK! |
CLICK! |
CLICK! |
| Maximum load |
500N |
500N |
500N |
500N |
| Width of chuck’s entrance |
0～0.5Φ |
0.5～1.0Φ |
1.0～1.5Φ |
1.5～2.0Φ |
| Material(part of tip) |
steel |
steel |
steel |
steel |
| Material(main body) |
Brass |
Brass |
Brass |
Brass |
|
|
- Please write “set” when you order a set of upper and
lower jig.
- We will remodel the above-mentioned special items to your requested jig.
- The above-mentioned special items have been manufactured by our company
before.
- We will produce special jigs depend on your request except for the
above-mentioned items.
Please feel free to contact us. |
It makes an effort as brought close to a color as original as possible, and
there is an image when it is actual and it differs somewhat from the color.
Please acknowledge it. |
