Data & check for building trust
home Product guide Technological material Proofreading Company introduction Inquiry
Home > Products guide > Measuring jig > Vise chuck Japanese site
Products guide
push-pull tester
digital force gauge
load stand
digital torque checker
measuring jigs
Flat type chuck
Film chuck
Wedge chuck
Pin chuck
Small chuck
Round stick chuck
Coiling chuck
Vise chuck
X-Y table
PC torque analyzer
software to take date & etc.
GV series
GV series - GV series is made of steel.
- It is suitable to chuck a little larger works.
- It is used for push & pull test.
- Examples
The bread down test of the connector and the cable is being operated by pull test with vertical load measuring stand (K-501H) and a push-pull gauge.   Pin chuck (CHP-15) and vise (GV-500N) are used.
Standard specification
Model GV-500N GV-5KN
External dimensional drawing CLICK! CLICK!
Maximum load 500N 5KN
Width of mouth 38mm 100mm
Openable range 35mm 100mm
Material steel steel

- We will remodel the above-mentioned special items to your requested jig.
We will produce special jigs depend on your request except for the above-mentioned items.
Please feel free to contact us.

It makes an effort as brought close to a color as original as possible, and there is an image when it is actual and it differs somewhat from the color.
Please acknowledge it.
All contents Copyright:ATTONIC
All Rights Reserved
ATTONIC LTD. 600-5, Higashitakada-cho, Toyohashi, Aichi, Japan
TEL+81-532-41-5357@FAX+81-532-41-4826