Data & check for building trust
home Product guide Technological material Proofreading Company introduction Inquiry
Home > Products guide > Measuring jig > Coiling chuck Japanese site
Products guide
push-pull tester
digital force gauge
load stand
digital torque checker
measuring jigs
Flat type chuck
Film chuck
Wedge chuck
Pin chuck
Small chuck
Round stick chuck
Coiling chuck
Vise chuck
X-Y table
PC torque analyzer
software to take date & etc.
CHR series
CHR series - CHR series is made of steel.
- It is suitable for the work such as wire and string.
- It is used for pull test.
- Examples
The breaking examination of wire is being operated by pulling test with vertical load measuring stand (K-501H) and a push-pull gauge.   A set of coiling chuck (CHR-05) is used.
Standard specification
Model CHR-05
External dimensional drawing CLICK!
Maximum load 500N
Maximum diameter of line 0.5Φ
Diameter of coil 10mm
- Please write “set” when you order a set of upper and lower jig.
- When you order a set, the board for installing resisting pressure board is attached to one side of the chuck.
The board for installing resisting pressure board isn’t attached when you order single unit.
If you need the board, you can get it optionally.
- We will remodel the above-mentioned special items to your requested jig.
- The above-mentioned special items have been manufactured by our company before.
We will produce special jigs depend on your request except for the above-mentioned items.
Please feel free to contact us.
It makes an effort as brought close to a color as original as possible, and there is an image when it is actual and it differs somewhat from the color.
Please acknowledge it.
All contents Copyright:ATTONIC
All Rights Reserved
ATTONIC LTD. 600-5, Higashitakada-cho, Toyohashi, Aichi, Japan
info@attonic.co.jp