Data & check for building trust
home Product guide Technological material Proofreading Company introduction Inquiry
Home > Products guide > Measuring jig > Wedge chuck Japanese site
Products guide
push-pull tester
digital force gauge
load stand
digital torque checker
measuring jigs
Flat type chuck
Film chuck
Wedge chuck
Pin chuck
Small chuck
Round stick chuck
Coiling chuck
Vise chuck
X-Y table
PC torque analyzer
software to take date & etc.
CHT series
CHT series - CHT series is made of steel.
- Works can be easily placed with the lever.
- It is used for pull test.
- Examples
The breaking test of the cable with the terminal is being operated with vertical load measuring stand (K-501H) and a push-pull gauge as below.   A set of wedge chuck (CHT-500N-8) is used.
Standard specification
Model CHT-500N-8 CHT-5KN-25
External dimensional drawing CLICK! CLICK!
Maximum load 500N 5KN
Width of chuck’s entrance 0〜5mm 0〜5mm
Size of tightening board 8mm 25mm
Shape of tightening surface Net Net
Material steel steel
- Please write “set” when you order a set of upper and lower jig. 
- We will remodel the above-mentioned special items to your requested jig.
- The above-mentioned special items have been manufactured by our company before.
- We will produce special jigs depend on your request except for the above-mentioned items.
Please feel free to contact us.
It makes an effort as brought close to a color as original as possible, and there is an image when it is actual and it differs somewhat from the color.
Please acknowledge it.
All contents Copyright:ATTONIC
All Rights Reserved
ATTONIC LTD. 600-5, Higashitakada-cho, Toyohashi, Aichi, Japan
info@attonic.co.jp